Swiss Plus SSF-1614 16-Inch Fan User Manual

SSF-1614

Safety precaution

Ensure that the voltage and power supply comply with the specifications indicated on the rating plate of the fan before plugging the fan into the main electrical supply.
Close supervision is necessary when the fan is used near children.
Do not leave the fan unattended when in use.
Always unplug the fan from the outlet when not in use and before cleaning it.
Do not immerse the fan in water while cleaning.
Always disconnect the fan from the power outlet when not in use.
Do not operate the fan with a damaged cord or plug, or after the fan has malfunctioned or has been damaged in any manner. Contact Morries Service Center for examination, repair of electrical/mechanical adjustment.
The adult should supervise the children in order to make sure the children can not play with the appliance.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Put the stand pole inside the base, then use the screw to fix the base and stand pole tightly. (Fig.1) Fig(1 )
Place the rear guard in the front cover of the motor and use the guard nut to faster the rear guard. (Fig. 2)

Fig(2)
Place the blade on the front axis of the motor and use the blade nut to fasten the blade. Make sure that the blade nut is tightened completely to prevent the blades from hitting the fan guard which will cause breakage. Fig( ) (Fig. 3)
Place the front guard together with the rear guard and fasten the clip. (Fig. 4)

Fig( 4 )
Release the adjustment knob and pull out the inner pipe from the stand pole. Tighten the adjustment knob when desired height is reached. (Fig. 5)

Always place the fan on a flat and stable surface.
Plug the fan into the power outlet and switch on.Ill
Select fan speed from" 1 ", "2" and "3". Select "0" to off the fan.
You may push down to oscillate the fan from left to right.
Timer can be activated and deactivated by turning the timer knob from "on" "off'' or 10. 20. 30. 40. 50. 60 minutes with timer

Before cleaning, unplug the fan from the power outlet and let it cool down completely.
Remove the guard and blade carefully. Avoid dropping the blades.
Use a soft cloth/sponge with mild soap to clean off all stains. Wipe it dry. Do not use any polish or corrosive liquids that may result in damaging the parts.
Allow the parts to dry before installing them into the fan.
Refer to assembly instructions.